DK Touring Canoe
Posted: Sat Jan 06, 2007 3:14 am
I just finished building my canoe from the free plans downloaded online. I really appreciate that. And I'm happy with the way it turned out. It went together quickly!
I'm a little concerned though with the strength of the bottom of the hull. I don't know if it will hold my weight. (220 lbs) I constructed it using 1/4" plywood. I glassed the bottom of the hull and the joints on the sides overlapping about 2". (I didnt glass the entire exterior of the hull and I didnt glass the interior of the hull at all) Also, I left out the supports for the interior as they were shown. Instead I used 2 thwarts and a yoke in the center. Now it occurs to me that maybe those supports were not only to support the sides of the hull, but the bottom as well.
The hull itself seems pretty strong due to the thwarts and yoke giving it rigidity. The bottom seems a little flimsy to me.
Do I need to glass the hull entirely inside and out for this design to work?
Or do you think it will be OK as is?
I'm a little concerned though with the strength of the bottom of the hull. I don't know if it will hold my weight. (220 lbs) I constructed it using 1/4" plywood. I glassed the bottom of the hull and the joints on the sides overlapping about 2". (I didnt glass the entire exterior of the hull and I didnt glass the interior of the hull at all) Also, I left out the supports for the interior as they were shown. Instead I used 2 thwarts and a yoke in the center. Now it occurs to me that maybe those supports were not only to support the sides of the hull, but the bottom as well.
The hull itself seems pretty strong due to the thwarts and yoke giving it rigidity. The bottom seems a little flimsy to me.
Do I need to glass the hull entirely inside and out for this design to work?
Or do you think it will be OK as is?
