Page 6 of 7
Re: North Wind
Posted: Thu Jan 08, 2009 6:24 pm
by jem
http://www.jemwatercraft.com/FreeRudderPlans.php
I need to get a picture of that rudder posted. Graham, do you have one?
Re: North Wind
Posted: Thu Jan 08, 2009 6:27 pm
by Graham
I will try been laid up with flu for a while but will try at the weekend.
How are you doing with the drawings is there much interest?
Re: North Wind
Posted: Thu Jan 08, 2009 7:04 pm
by jem
20 downloads so far.
Re: North Wind
Posted: Fri Jan 09, 2009 2:17 pm
by Graham
Great news I will try to drag myself out of bed tomorrow and venture down to the shop. The temperature is now above freezing and the door was frozen shut.
Naff excuse I know!
Re: North Wind
Posted: Thu Jan 15, 2009 1:55 pm
by tx river rat
Matt
Reading some of Micks post , brings up a question, Is the southwind based on the clipper and the northwind based on the sea wind.
Ron
Re: North Wind
Posted: Thu Jan 15, 2009 2:32 pm
by jem
tx river rat wrote:Matt
Reading some of Micks post , brings up a question, Is the southwind based on the clipper and the northwind based on the sea wind.
Ron
yes and yes
Re: North Wind
Posted: Sat Jan 17, 2009 9:07 pm
by tx river rat
I just reread this thread and I have another question ,if you set the foot peggs up as rudder control is there a way to have another set to brace against when you are using a yak paddle.
Ron
Re: North Wind
Posted: Sat Jan 17, 2009 9:17 pm
by jem
Buy these:
http://www.duckworksbbs.com/hardware/canoe-kayak/rudder-fb/index.htm
Re: North Wind
Posted: Tue Oct 13, 2009 9:07 am
by Darrells
Matt,
Would it be possible to strip build flat panels for this boat and then cut as per plans. I know the twists might be tough but is it possible?
Re: North Wind
Posted: Tue Oct 13, 2009 6:28 pm
by jem
Darrells wrote:Matt,
Would it be possible to strip build flat panels for this boat and then cut as per plans. I know the twists might be tough but is it possible?
You could. But that's a lot of work. Might as well fully strip build it. I can help with that!
