Page 1 of 1
Wadefish Instructions
Posted: Tue Jan 02, 2007 10:15 am
by Mullet_Key
Matt, just started, the cockpit frame is going together well. In regards to the two frames that are postioned fore & aft.., about the size of dinner platters, those are temporary correct?
The vertical tankwell support, does it span the the rear mid-deck crossmember and the sole? or just under the tankwell? MK
Re: Wadefish Instructions
Posted: Tue Jan 02, 2007 10:32 am
by jem
Mullet_Key wrote:Matt, just started, the cockpit frame is going together well. In regards to the two frames that are postioned fore & aft.., about the size of dinner platters, those are temporary correct?
Yes those will be removed before final assembly. You could use them for backing plates for any though-hull holes you might want to drill for pad eyes or rod holders.
Mullet_Key wrote:The vertical tankwell support, does it span the the rear mid-deck crossmember and the sole? or just under the tankwell? MK
I drew it up so you could trim it to just support/span the tankwell. You trim it after the main hull is assembled.